Electrician Dispatch Toronto · Bloor West

Pot light installation in the west end

Recessed LED lighting for living rooms, kitchens, basements and soffits, planned around how you use each room and installed with as little patching as possible.

Lighting older rooms

West-end houses come with lighting challenges of their own. Edwardian and Victorian houses in Roncesvalles and Parkdale often have tall ceilings, plaster medallions and crown moulding worth keeping. Bloor West and Swansea homes tend to have smaller rooms that were lit by a single ceiling fixture and a lot of lamps. Basements everywhere were never meant to be living space. Pot lights fix all of that, as long as they are planned for the room rather than dropped in a grid.

In a typical Bloor West semi, the living room, dining room and kitchen can often all be relit in a day or two. Basements being finished in High Park North and the Junction are usually the easiest of all, because the ceiling is still open and the wiring can be run before the drywall goes up.

How we plan a layout

  • Living rooms: lights set back from the walls to wash them with light, with care around the TV wall so there is no glare on the screen.
  • Kitchens: lights lined up over the front edge of the counters, plus under-cabinet lighting, so you are never working in your own shadow.
  • Basements: slim wafer lights that fit under ductwork and low joists, often on two or three zones.
  • Exteriors: soffit lights that show off the brick and light the walk and steps, on a timer, photocell or smart switch.

We mark every location on the ceiling and agree on it with you before anything is cut.

Clean installs in plaster and drywall

Slim LED fixtures need no bulky housing, which means smaller holes and fewer access cuts. Wire is fished between joists wherever possible. In plaster ceilings we cut slowly with the right blades to avoid cracking. Lights under an attic or roof are IC-rated and airtight, so they can sit in insulation without leaking heat. Every room gets an LED-compatible dimmer matched to its fixtures, so the lights dim smoothly from full to a low glow without flicker or hum. Colour-selectable fixtures let you choose a warm 2700K or 3000K for living spaces and something crisper for a kitchen or workshop.

How a pot light job runs

  1. Photos and a rough count. Send photos of the rooms and tell us roughly what you are after.
  2. Layout on the ceiling. We mark positions and switch locations with you on site before cutting.
  3. Install. Fish, wire, mount and connect. One or two rooms is usually a single day.
  4. Final check. All lights and dimmers tested together, and the work area cleaned up.

Pot light FAQ

Can pot lights go into a plaster ceiling?

Yes. Plaster needs slower, more careful cutting than drywall, but slim LED fixtures make it very manageable.

What colour temperature should I choose?

2700K to 3000K is warm and suits most living spaces. 3500K to 4000K is brighter and crisper for kitchens, laundry rooms and workshops. Colour-selectable fixtures let you decide on the day.

Will my existing dimmer work with LED pot lights?

Often not well. Older dimmers were made for incandescent bulbs and can cause flicker or buzzing with LEDs. We install dimmers rated for the fixtures.

Do you install exterior soffit lights?

Yes, including the switching or timers to control them. They are a popular upgrade on west-end brick houses.

How many pot lights will I need?

It depends on the room size, ceiling height and how bright you like it. As a rough guide, lights end up four to six feet apart, but we lay them out around the furniture and cabinets rather than a formula, and we will tell you if you are planning more than the room needs.