Most repairs start with a loose connection
In houses built between the wars, a lot of the wiring has been added to over a century: a basement circuit in the 1960s, a kitchen in the 1990s, a few outlets wherever the last owner needed them. When something stops working, the cause is usually a connection that has loosened or overheated at a device, a junction box or the panel, not the whole circuit.
We trace the fault before replacing anything, so you pay for the repair and not for guesses.
Calls we get most in the west end
- Half the room is dead. Often a failed connection at one outlet that feeds the rest, or a GFCI that tripped somewhere unexpected, like a bathroom or the porch.
- A breaker that will not stay on. Either a fault on the circuit or too much load on it. We find out which before resetting it again.
- Lights that flicker or dim. On one fixture it is usually the fixture or switch. Across the house it can be a loose neutral, which needs attention the same day.
- Warm or discoloured outlets and switches. Turn that circuit off and call. Heat at a device means a connection is failing.
- Two-prong outlets. Common in Swansea and Baby Point houses. A GFCI outlet, labelled correctly, is an approved fix where running a new ground is not practical.
How a repair visit works
- Call or text. Tell us what stopped working and what changed just before. A photo of the panel helps.
- Find the cause. We test the circuit and open the boxes involved.
- Repair and explain. We fix it, show you what failed, and tell you if anything else on that circuit should be looked at.
If the repair turns up original wiring, see knob-and-tube replacement or home rewiring.