Electrician Dispatch Toronto · Bloor West

EV charger installation in Bloor West, High Park and the Junction

Level 2 home charging installed on a dedicated 240 volt circuit, whether you park in an attached garage, on a mutual drive or in a detached garage off the laneway.

Where you park decides the job

West-end parking is all over the map. Swansea and Baby Point have more private driveways and attached garages. Bloor West Village and High Park North have plenty of mutual drives and detached garages at the back of the lot. In Roncesvalles, Parkdale and the Junction, parking is often a laneway garage or nothing at all. The charger location sets how long the run is and how it gets there:

  • Attached garage or basement wall near the panel: usually a short, simple run.
  • Detached garage: a feed from the house, either overhead or in buried conduit across the yard, often to a small sub-panel in the garage.
  • Driveway or exterior wall: an outdoor-rated charger or receptacle, mounted where the cable reaches the car without crossing a walkway.

Can your panel handle it?

A Level 2 charger usually needs a 40 to 60 amp circuit. On a west-end house that is still on 100 amps, that is a big ask, so every job starts with a load calculation. If there is room, we add the circuit. If it is tight, an EV energy management system can share capacity with the rest of the house by slowing or pausing charging when other big loads are running. If there is no room at all, the charger is planned together with a panel or service upgrade.

Chargers we install

We install the common home chargers, including Tesla Wall Connector, ChargePoint Home Flex, Grizzl-E, FLO Home and Emporia, and we can recommend one if you have not chosen yet. Hardwired units are the better choice for most people: they handle higher currents, have fewer connection points and do not depend on a receptacle that can wear out. Tell us which car you drive and where you park, and we will match the charger and circuit to it. The installation is done under an ESA permit and inspected.

How an EV charger install runs

  1. Send photos. Your panel, the parking spot and the route between them. Include the car and charger model if you have them.
  2. Load check and plan. We confirm capacity and choose between a direct circuit, load management or an upgrade.
  3. Install. Circuit, conduit or cable run, and charger mounted. A straightforward install is usually done in one visit; a detached garage takes longer.
  4. Commission. We set the charger to match the breaker and test it, with your car if it is home.

EV charger FAQ

Can you run power to my detached garage?

Yes. It is one of the most common west-end installs. Depending on the yard, it is either an overhead feed or buried conduit, usually to a small sub-panel that can also power lights and receptacles in the garage.

How long does a charger install take?

A charger near the panel is usually a single visit. Detached garages with trenching take longer, and a panel or service upgrade adds scheduling time with Toronto Hydro.

Do I need a 200 amp service for an EV?

Not necessarily. Many 100 amp houses can add a charger with load management or a modest charging current. The load calculation tells us which.

Can I charge from a regular outlet instead?

A standard 120 volt outlet adds only a few kilometres of range per hour. It can work for short commutes, but most owners find Level 2 is what makes an EV practical day to day.